Differences

This shows you the differences between two versions of the page.

--- cisco_inter_vlan_routing [2024/01/21 00:29] – [IP Routing] walkeradmin
+++ cisco_inter_vlan_routing [2024/01/21 13:36] (current) – walkeradmin
@@ Line 1: / Line 1: @@
 ====== Cisco Inter VLAN Routing ======
+==== aka Switch Virtual Interfaces (SVI) or Management Interface ====
 <color #db5f0b>Jan 2024</color>
 \\
@@ Line 173: / Line 174: @@
 ==== IP Routing ====
 As a quick reminder, here is a diagram of the network we are using:
+\\
 \\
 {{ :vlanr_003.png?900 |}}
@@ Line 193: / Line 195: @@
 \\
 \\
-To enable IP Routing on the switch, we will use the following:
+To enable <color #ed1c24>IP Routing</color> on the switch, we will use the following:
 \\
+  en
+  conf t
+  ip routing
+  end
+There is no text return from running this command.
 \\
+\\
+No we can test to see the routes by using the following:
 <file>
 sh ip route
@@ Line 213: / Line 222: @@
 C    192.168.1.0/24 is directly connected, Vlan10
 </file>
+\\
+We can see that the two <color #ed1c24>interface VLANs</color> are shown (10.43.30.0 is directly connected, Vlan20 and 192.168.1.0/24 is directly connected, Vlan10).
 \\
-Now try to ping from Device A (192.168.1.38) to Device B (10.43.30.100). Remember, the gateway of Device A must be the IP Address of VLAN 10 (192.168.1.1 in this example).
 \\
+Now try to ping from Device A (192.168.1.38) to Device B (10.43.30.100). Remember, the gateway of Device A must be the IP Address of VLAN 10 (192.168.1.1 in this example).
 \\
 <file>
@@ Line 224: / Line 235: @@
 Reply from 10.43.30.100: bytes=32 time<1ms TTL=127
 </file>
-\\
 Now we can communicate with devices in VLAN 20 from VLAN 10.
 \\