Differences

This shows you the differences between two versions of the page.

--- wiki:ifup_and_ifdown [2020/04/29 15:20] – walkeradmin
+++ wiki:ifup_and_ifdown [2023/08/17 17:37] (current) – walkeradmin
@@ Line 11: / Line 11: @@
 \\
 \\
+----
 ==== Simple Syntax ====
 \\
 So, to take down an interface, I would use the following:
+\\
 \\
 <color #ed1c24>ifdown eth1</color>
 \\
 Device 'eth1' successfully disconnected.
+\\
 \\
 \\
@@ Line 31: / Line 36: @@
 \\
 \\
+----
+**What Went Wrong?**
+\\
+\\
+Now, this is not going to affect everyone, but in our systems we sometimes have to prove redundancy by taking down an interface, letting a device detect this and watching the system automatically switch. Sounds simple enough, but it seems that using a simple <color #ed1c24>ifdown</color> or <color #ed1c24>ifup</color> does not cause a redundancy switch, you need to do a bit more.
+\\
+\\
+To properly take the interface down, so that it is recognised as being down from a 'link'perspective, you must use the following syntax:
+\\
+\\
+<color #ed1c24>ip link set eth1 down</color> (obviously use your interface name, not mine)
+\\
+\\
+And inversly:
+\\
+\\
+<color #ed1c24>ip link set eth1 up</color>
+\\
+\\
+This will ensure that the interface goes fully down, and that other devices can recognize that the interface is down.
+\\
+\\
+I sincerely hope this saves you some pain :)
+\\
+\\
+\\