Differences

This shows you the differences between two versions of the page.

--- vlan_tagging [2024/03/19 17:51] – [Cisco Configuration] walkeradmin
+++ vlan_tagging [2024/03/19 18:00] (current) – [Cisco Configuration] walkeradmin
@@ Line 317: / Line 317: @@
                                                 Gi0/45, Gi0/46, Gi0/48
 </file>
+\\
+We can create the VLAN and add the interface to it in one line on the cisco:
+  en
+  conf t
+  int gigabitEthernet 0/45
+  switchport access vlan 101
+\\
+If the VLAN does not exist, you will see this message:
+  % Access VLAN does not exist. Creating vlan 101
+Repeat these steps for all other required VLANs.
+\\
+\\
+<file>
+VLAN Name                             Status    Ports
+---- -------------------------------- --------- -------------------------------
+    default                          active
+   VLAN0010                         active    Gi0/1, Gi0/2, Gi0/3, Gi0/4
+                                                Gi0/5, Gi0/6, Gi0/7, Gi0/8
+                                                Gi0/9, Gi0/10, Gi0/11, Gi0/12
+   VLAN0020                         active    Gi0/13, Gi0/14, Gi0/15, Gi0/16
+                                                Gi0/17, Gi0/18, Gi0/19, Gi0/20
+                                                Gi0/21, Gi0/22, Gi0/23, Gi0/24
+   VLAN0030                         active    Gi0/25, Gi0/26, Gi0/27, Gi0/28
+                                                Gi0/29, Gi0/30, Gi0/31, Gi0/32
+                                                Gi0/33, Gi0/34, Gi0/35, Gi0/36
+   VLAN0040                         active    Gi0/37, Gi0/38, Gi0/39, Gi0/40
+                                                Gi0/41, Gi0/42, Gi0/43, Gi0/44
+                                                Gi0/48
+  VLAN0101                         active    Gi0/45
+  VLAN0102                         active    Gi0/46
+</file>
+\\
+Above we can see the two new VLANs of 101 and 102, and in these VLANs are the respective interfaces of Gi0/45 and Gi0/46. That should be it, now Save your Cisco configuration.
+\\
+As per the diagram below:
+{{:vlan_tagging_001.png?900|}}
+\\
+\\
+\\
+We should observe now that we can connect to the Multicast 239.0.100.1:1234 when connected to interface 45 on the switch (which has the traffic tagged as 101), but we will not see the Multicast 23.0.100.2:1234 unless we connect to interface 46 on the Cisco switch (which has the traffic tagged as 102).
+\\
+\\
@@ Line 323: / Line 366: @@
-That should be it, now Save your Cisco configuration.