rx1_modulated_input
This is an old revision of the document!
Table of Contents
RX1 Modulated Input
Nov 2023
Introduction
It has been quite some number of years since I dealt with Modulators and Receivers, so I did struggle a little with this recently, these are some notes of the values I used, just to get a Mod/Demod setup going.
Hardware Connections
See below for the connection method between the AVP and the RX1.
The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use.
AVP Output Parameters
Below is the output settings I used on the AVP Modulator.
rx1_modulated_input.1699370220.txt.gz · Last modified: 2023/11/07 15:17 by walkeradmin