gphoto2_auto_detect
gphoto2 auto detect
Jun 2017
Without any camera connected to the Raspberry Pi, run this command:
gphoto2 --auto-detect
You should see an output as follows:
Model Port ----------------------------------------------------------
Now connect your camera via USB to your Raspberry Pi, and again run the command:
gphoto2 --auto-detect
Now if your camera is detected (and I am assuming that means supported) you should see a successful detection. Bear in mind that, after about 2 minutes your camera will auto shut-off, so if you have been reading this page your camera could already be off, just hit the shutter button to wake it up.
Model Port ---------------------------------------------------------- Canon EOS 700D usb:001,005
Here we can see that I have connected a Canon EOS 700D, and it is visible on usb:001,005. (the number does seem to change, the second time I tried this on my 700D I got usb:001,007).
gphoto2_auto_detect.txt · Last modified: 2023/03/09 22:35 by 127.0.0.1