el_advanced_parameters_linear_broadcast
This is an old revision of the document!
EL Advanced Parameters Linear Broadcast
Jun 2021
Introduction
There are many Advanced Parameters that can be used with Encoding Live, but this set gives good performance when using the Linear Broadcast solution, you get CBR outputs from the ELs as well as a few other things to tidy up the stream
These parameters are added on the 'Advanced Parameters' tab when setting up an EL Encode (it is the last tab). The page has two fields, one for the Advanced Parameter and one for the operator. The operator on all of these is 'True'.
pcr.newClock rtp.keepStuffing mpeg2ts.statmux.cbr.stuffing statmux.useServiceNameInProfileName mpeg2ts.audio.NullPacketStuffing mpeg2ts.private.NullPacketStuffing
All set to true.
Some newer APs are:
For statmux:
statmux.announce.addr x.x.x.x (where x.x.x.x is the statMuxAnnouncer address from the Mux(
For QSV (2SG1 cards)
qsv.useSoftwareDecoder true qsv.Encoder.DequantType 0
el_advanced_parameters_linear_broadcast.1696250624.txt.gz · Last modified: 2023/10/02 13:43 by walkeradmin