Differences

This shows you the differences between two versions of the page.

--- view_statmux_messages_ssh [2024/04/24 17:02] – walkeradmin
+++ view_statmux_messages_ssh [2024/04/24 17:08] (current) – walkeradmin
@@ Line 5: / Line 5: @@
 ----
-When using
+StatMux messages originate from the Multiplexer and are received by the Encoding Live. Even though the Encoder may be started, it will not output anything when in a StatMux group if it does not receive any StatMux messaging.
+\\
+\\
+Remember, for this to work the Encoder and Mux have to be started, and the StatMux group has to be set in both the Multiplexer and the Encoder.
+\\
+\\
+In this example I am looking at eno3 on Encoder, this is because in this example the StatMux messages are going across the Data Network.
+\\
+\\
+We can use the following to see the StatMux messages:
+\\
+\\
+  tcpdump -i eno3 -nn port 15778
 <file>
-tcpdump -i eno3 -nn port 15778
 tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
 listening on eno3, link-type EN10MB (Ethernet), capture size 262144 bytes
@@ Line 31: / Line 35: @@
 :59:20.320564 IP 11.0.213.3.15778 > 239.225.0.1.15778: UDP, length 61
 :59:20.865892 IP 11.0.213.3.15778 > 239.225.0.1.15778: UDP, length 61
 </file>
+\\
+<color #00a2e8>11.0.231.3</color> is the source address the StatMux messages are coming from, in my example this is the first Data Interface on the Mux.
+\\
+\\
+<color #00a2e8>239.225.0.1</color> is the Multicast that was configured when setting up the system as the StatMux Multicast Address.
+\\
+\\
+<color #00a2e8>15778</color> is the default port used for StatMux multicast messages.
+\\
+\\
+----