led_pwm_control
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
led_pwm_control [2017/01/23 18:52] – [LED States] walkeradmin | led_pwm_control [2017/02/01 10:34] – walkeradmin | ||
---|---|---|---|
Line 2: | Line 2: | ||
<color # | <color # | ||
\\ | \\ | ||
+ | \\ | ||
+ | {{: | ||
---- | ---- | ||
Turning on LEDs using the GPIO on the Raspberry Pi is pretty simple. You just turn on or off the relevant GPIO pin, and your LED (connected via a 330r resistor) will come on and go off. | Turning on LEDs using the GPIO on the Raspberry Pi is pretty simple. You just turn on or off the relevant GPIO pin, and your LED (connected via a 330r resistor) will come on and go off. | ||
Line 83: | Line 84: | ||
==== LED States ==== | ==== LED States ==== | ||
\\ | \\ | ||
- | {{: | + | {{: |
+ | \\ | ||
+ | \\ | ||
+ | ---------PWM-001------------PWM-010------------PWM-050------------PWM-0100--------------PWM-250--------------PWM-500--------------PWM-999-------- |
led_pwm_control.txt · Last modified: 2023/03/09 22:35 by 127.0.0.1