gpio_control_from_command_line
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| gpio_control_from_command_line [2017/01/22 14:19] – [Using gpio command] walkeradmin | gpio_control_from_command_line [2017/01/22 16:06] – [Install WiringPi] walkeradmin | ||
|---|---|---|---|
| Line 47: | Line 47: | ||
| \\ | \\ | ||
| \\ | \\ | ||
| - | gpio -readall | + | gpio readall |
| \\ | \\ | ||
| This will give an output similar to below (This output is from a Pi Zero v1.3) | This will give an output similar to below (This output is from a Pi Zero v1.3) | ||
gpio_control_from_command_line.txt · Last modified: 2023/03/09 22:35 by 127.0.0.1