el_single_server_change_ip_address_alma_linux
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
el_single_server_change_ip_address_alma_linux [2024/02/06 20:02] – [Installing MK Software] walkeradmin | el_single_server_change_ip_address_alma_linux [2024/02/06 20:11] (current) – walkeradmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== EL / Single Server Change IP Address Alma Linux ====== | ====== EL / Single Server Change IP Address Alma Linux ====== | ||
- | <color #db5f0b>Jan 2024</ | + | <color #db5f0b>Feb 2024</ |
\\ | \\ | ||
\\ | \\ | ||
Line 22: | Line 22: | ||
\\ | \\ | ||
\\ | \\ | ||
+ | If your Server Software is already installed, and you know that Controller was installed using 127.0.0.1 and all you need to do is change Management IP Address, then skip to the last section in the article - " | ||
---- | ---- | ||
==== Server Pre-Requisites ==== | ==== Server Pre-Requisites ==== | ||
Line 125: | Line 126: | ||
| | ||
\\ | \\ | ||
- | | + | < |
- | ./ | + | tar -xvf installer-multiplexer-el8-*.tar.gz |
+ | ./ | ||
+ | </ | ||
+ | ---- | ||
+ | All SW should now be installed, check the UI. | ||
+ | \\ | ||
+ | \\ | ||
+ | I am not sure if a reboot would be best here. Will not hurt to do a reboot at this point. | ||
+ | \\ | ||
+ | ---- | ||
+ | ==== Management IP Address Change ==== | ||
+ | The only IP Address that needs to be changed is for Encoding Live. Controller is using 127.0.0.1 under the hood and RT and Mux didn't have an IP Address specified during the installation. | ||
+ | \\ | ||
+ | change the IP Address in /etc/hosts to the new management IP Address | ||
+ | change the server IP in / | ||
+ | reboot the server | ||
+ | |||
+ | The Server reboot will make the IP Address and Host Name changes live | ||
+ | \\ | ||
+ | Navigate to: / | ||
+ | change the current IP Addresses for EL and LicenseServer | ||
+ | then run the last_configure.sh with no switches | ||
+ | ./ | ||
+ | \\ | ||
+ | ---- | ||
+ | Now re-test the server functionality, | ||
+ | \\ | ||
+ | \\ | ||
el_single_server_change_ip_address_alma_linux.1707249760.txt.gz · Last modified: 2024/02/06 20:02 by walkeradmin