Differences

This shows you the differences between two versions of the page.

--- el_1_1_sync [2023/11/08 17:10] – [Services Synchronisation] walkeradmin
+++ el_1_1_sync [2023/11/08 17:15] (current) – [Dual Output Prevention] walkeradmin
@@ Line 32: / Line 32: @@
 Port                Set the port you wish to use (can be the same on all services)
-The Multicast and Port can be the same as long as the Pool Name is unique on all services
+The Multicast Address and Port can be the same as long as the Pool Name is unique on all services
 </file>
 This has to be configured the same on both 1+1 Encoders (or split encoders)
@@ Line 45: / Line 45: @@
 \\
 \\
+This section is similar to the 'services synchronisation' but has a few less settings:
+\\
+<file>
+Network Interface          The interface you wish to run the comms on (in this case, mngt is a teamed interface)
+Address                    The Multicast address for the messaging (can be the same for each service)
+Port                       The Multicast Port (can be the same for each service)
+Group name                 Must be a unique value, I normally use the channel/service name.
+The Multicast Address and Port can be the same as long as the Pool Name is unique on all services
+</file>
+\\
+\\
+----
+Remember that both 'Services Synchronisation' and 'Dual Output Prevention' only run in 1+1 scenarios.
+\\
+\\