rx1_modulated_input
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
rx1_modulated_input [2023/11/07 15:24] – walkeradmin | rx1_modulated_input [2023/11/07 15:43] (current) – [RX1 Input Status] walkeradmin | ||
---|---|---|---|
Line 12: | Line 12: | ||
\\ | \\ | ||
\\ | \\ | ||
- | {{ : | + | {{ : |
\\ | \\ | ||
The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use. | The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use. | ||
Line 46: | Line 46: | ||
Upconverter Reference | Upconverter Reference | ||
</ | </ | ||
- | |||
\\ | \\ | ||
\\ | \\ | ||
+ | The settings on this page determine what frequency you are transmitting on. | ||
+ | \\ | ||
+ | \\ | ||
+ | ---- | ||
+ | ==== AVP Modulation Parameters ==== | ||
+ | Below is the Modulation settings I used on the AVP Modulator. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | < | ||
+ | Modulation Standard | ||
+ | Modulation State On | ||
+ | Modulation | ||
+ | FEC Rate 3/4 | ||
+ | Frame Size | ||
+ | Pilots | ||
+ | NCR Stamping PID 8191 | ||
+ | Symbol Mapping Mode Mean Power | ||
+ | PL Scrambling Sequence Number | ||
+ | Symbol Rate 31.25 | ||
+ | Roll-off Factor | ||
+ | Bandwidth | ||
+ | </ | ||
+ | \\ | ||
+ | The settings on this page determine the amount of bandwidth that is available, in this case it is 37.5 Mhz. | ||
+ | \\ | ||
+ | \\ | ||
+ | ---- | ||
+ | ==== RX1 Input Settings ==== | ||
+ | See Below for the RX1 Demodulation settings. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | \\ | ||
+ | < | ||
+ | Input Type Satellite | ||
+ | Source | ||
+ | LNB | ||
+ | LNB Frequency | ||
+ | LNB Voltage | ||
+ | 22kHz not selected, same reason as above. | ||
+ | |||
+ | Tuner | ||
+ | Frequency | ||
+ | Symbol Rate 31.25 | ||
+ | Search Range 10000 | ||
+ | C/N margin alarm 2.0 | ||
+ | |||
+ | Everything else off. | ||
+ | </ | ||
+ | \\ | ||
+ | \\ | ||
+ | ==== RX1 Input Status ==== | ||
+ | \\ | ||
+ | On the same page as you entered the RX1 demodulation settings, once you have started the receiver service, you should see the following input status. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | \\ | ||
rx1_modulated_input.1699370665.txt.gz · Last modified: 2023/11/07 15:24 by walkeradmin