serial_over_lan_connection_issues
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
serial_over_lan_connection_issues [2018/11/29 16:24] – walkeradmin | serial_over_lan_connection_issues [2018/11/30 10:46] – walkeradmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Serial over LAN connection issues ====== | ====== Serial over LAN connection issues ====== | ||
<color darkorange> | <color darkorange> | ||
- | \\ | ||
- | \\ | ||
- | |||
- | <color # | ||
- | \\ | ||
\\ | \\ | ||
\\ | \\ | ||
Line 62: | Line 57: | ||
Above we can see the Serial Over LAN port selection. When you are connected to the T1 via a Serial Console connection, you can use the following command: | Above we can see the Serial Over LAN port selection. When you are connected to the T1 via a Serial Console connection, you can use the following command: | ||
\\ | \\ | ||
- | ctrl g no | + | ctrl g number |
\\ | \\ | ||
\\ | \\ | ||
Line 69: | Line 64: | ||
\\ | \\ | ||
ctrl g 1 | ctrl g 1 | ||
+ | | ||
+ | Remember | ||
+ | ctrl-g 0 is the switch | ||
+ | ctrl-g 1-9 are the sleds | ||
\\ | \\ | ||
\\ | \\ | ||
Line 77: | Line 76: | ||
\\ | \\ | ||
\\ | \\ | ||
- | <color # | + | <color # |
\\ | \\ | ||
\\ | \\ | ||
Line 96: | Line 95: | ||
\\ | \\ | ||
\\ | \\ | ||
- | The error <color # | + | The error <color # |
\\ | \\ | ||
\\ | \\ | ||
- | SSH to the BMC, and from the command line run the following command: | + | You might have to toggle between the BCM and Payload a couple of times to get the BCM to respond (ctrl gg 0, then ctrl gg 1, then ctrl-gg 0) and keep hitting enter until you get a response. |
+ | \\ | ||
+ | \\ | ||
+ | Once connected | ||
\\ | \\ | ||
mc reset cold | mc reset cold | ||
Line 109: | Line 111: | ||
---- | ---- | ||
\\ | \\ | ||
- | ==== Console dropped due to BP Com Request | + | ==== Connection Stops at SOL Session Operational. Use ~? for help Error ==== |
- | / | + | If you get this far <color # |
- | + | \\ | |
- | edit this file from this: | + | \\ |
+ | Again, you will either have to connect to the OS with SSH or using the Keyboard / Monitor locally. | ||
+ | \\ | ||
+ | \\ | ||
+ | Edit the following file: | ||
+ | \\ | ||
+ | \\ | ||
+ | | ||
+ | \\ | ||
+ | \\ | ||
+ | Edit this file from this: | ||
\\ | \\ | ||
< | < |
serial_over_lan_connection_issues.txt · Last modified: 2023/03/09 22:35 by 127.0.0.1