rx9004_rear_panel
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
rx9004_rear_panel [2017/02/13 07:34] – created walkeradmin | rx9004_rear_panel [2017/02/13 14:20] – walkeradmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== RX9004 Rear Panel ====== | ====== RX9004 Rear Panel ====== | ||
+ | <color darkorange> | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | ---- | ||
+ | |||
+ | The RX9004 Rear panel is shown below. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | * S1 is generally what we use for ASI Inputs. | ||
+ | |||
+ | * LAN1 is used for control (but can be used for data) | ||
+ | |||
+ | * LAN2 is generally used for data input (unless you are using ASI Input). | ||
+ | |||
+ | * I have not seen LAN3/LAN4 on any Ericsson units yet. | ||
+ | |||
+ | * BNC1/ | ||
+ | \\ | ||
+ | \\ | ||
+ | There are five spigots on the SDI card, the correct order is as follows: | ||
+ | \\ | ||
+ | \\ | ||
+ | {{: | ||
rx9004_rear_panel.txt · Last modified: 2023/03/09 22:35 by 127.0.0.1