rx1_modulated_input
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
rx1_modulated_input [2023/11/07 15:39] – [RX1 Input Settings] walkeradmin | rx1_modulated_input [2023/11/07 15:43] (current) – [RX1 Input Status] walkeradmin | ||
---|---|---|---|
Line 12: | Line 12: | ||
\\ | \\ | ||
\\ | \\ | ||
- | {{ : | + | {{ : |
\\ | \\ | ||
The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use. | The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use. | ||
Line 81: | Line 81: | ||
\\ | \\ | ||
\\ | \\ | ||
- | {{ : | + | {{ : |
\\ | \\ | ||
\\ | \\ | ||
Line 102: | Line 102: | ||
Everything else off. | Everything else off. | ||
</ | </ | ||
+ | \\ | ||
+ | \\ | ||
+ | ==== RX1 Input Status ==== | ||
+ | \\ | ||
+ | On the same page as you entered the RX1 demodulation settings, once you have started the receiver service, you should see the following input status. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
\\ | \\ | ||
\\ | \\ | ||
rx1_modulated_input.txt · Last modified: 2023/11/07 15:43 by walkeradmin