Differences

This shows you the differences between two versions of the page.

--- rx1_modulated_input [2023/11/07 15:39] – [RX1 Input Settings] walkeradmin
+++ rx1_modulated_input [2023/11/07 15:43] – walkeradmin
@@ Line 12: / Line 12: @@
 \\
 \\
-{{ :avp_rx1.jpg?nolink&800 |}}
+{{ :avp_rx1.jpg?nolink&700 |}}
 \\
 The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use.
@@ Line 81: / Line 81: @@
 \\
 \\
-{{ :rx1_modulator_input.jpg?nolink&800 |}}
+{{ :rx1_modulator_input.jpg?nolink&700 |}}
 \\
 \\
@@ Line 102: / Line 102: @@
 Everything else off.
 </file>
+\\
+\\
+==== RX1 Input Status ====
+\\
+On the same page as you entered the RX1 demodulation settings, once you have started the receiver service, you should see the following input status.
+\\
+\\
+{{ :rx1_input_status.jpg?nolink&700 |}}
 \\
 \\