Differences

This shows you the differences between two versions of the page.

--- rx1_modulated_input [2023/11/07 15:34] – walkeradmin
+++ rx1_modulated_input [2023/11/07 15:43] – walkeradmin
@@ Line 12: / Line 12: @@
 \\
 \\
-{{ :avp_rx1.jpg?nolink&800 |}}
+{{ :avp_rx1.jpg?nolink&700 |}}
 \\
 The Monitor F-Type output of the AVP is connected directly to the RF input of the RX1 (RX4 is on the left). There is no up-convertor or attenuator in use.
@@ Line 81: / Line 81: @@
 \\
 \\
-{{ :rx1_modulator_input.jpg?nolink&800 |}}
+{{ :rx1_modulator_input.jpg?nolink&700 |}}
+\\
+\\
+<file>
+Input Type            Satellite
+Source                RF4 (in this example)
+LNB
+LNB Frequency         5150
+LNB Voltage           (voltage off) this is because we don't actually have an LNB in our system.
+kHz                 not selected, same reason as above.
+Tuner
+Frequency             4080 (5150-4080=1070. 1070 is the L-Band Freq we set in the AVP)
+Symbol Rate           31.25
+Search Range          10000
+C/N margin alarm      2.0
+Everything else off.
+</file>
+\\
+\\
+==== RX1 Input Status ====
+\\
+On the same page as you entered the RX1 demodulation settings, once you have started the receiver service, you should see the following input status.
+\\
+\\
+{{ :rx1_input_status.jpg?nolink&700 |}}
 \\
 \\