led_pwm_control
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| led_pwm_control [2017/01/23 18:22] – [Using PWM from the Command Line] walkeradmin | led_pwm_control [2017/01/23 18:23] – [Setup the GPIO Pin as an Output] walkeradmin | ||
|---|---|---|---|
| Line 49: | Line 49: | ||
| * Setup the Pin in PWM Mode | * Setup the Pin in PWM Mode | ||
| * Start the PWM | * Start the PWM | ||
| - | \\ | + | |
| - | \\ | + | |
| ---- | ---- | ||
| Line 61: | Line 60: | ||
| This sets the mode to Output | This sets the mode to Output | ||
| \\ | \\ | ||
| + | |||
| + | ---- | ||
| + | |||
| ==== Set the GPIO Pin Mode to PWM === | ==== Set the GPIO Pin Mode to PWM === | ||
| \\ | \\ | ||
| Line 76: | Line 78: | ||
| \\ | \\ | ||
| \\ | \\ | ||
| - | |||
| - | |||
| - | |||
| - | |||
| - | |||
| - | pi@PiNTP:~ $ gpio -g pwm 12 50 | ||
| - | |||
led_pwm_control.txt · Last modified: 2023/03/09 22:35 by 127.0.0.1