Differences

This shows you the differences between two versions of the page.

--- interfaces_vswitches_and_port_groups [2017/07/18 11:28] – walkeradmin
+++ interfaces_vswitches_and_port_groups [2017/07/18 11:32] – [Terminology] walkeradmin
@@ Line 20: / Line 20: @@
 \\
 <color #22b14c>vmnic</color> - This is the name VMWare has assigned to each of your physical interfaces. So on my server I have <color #22b14c>vmnic0</color> to <color #22b14c>vmnic11</color> (<color #22b14c>vmnic0</color> is my connected to my management switch, vmnic7 is connected to my data switch).
+\\
+\\
+{{ :vmware_interfaces.jpg?350 |}}
 \\
 \\
@@ Line 37: / Line 40: @@
 \\
 In the example below we can see that the third physical interface is connected to both VMs (the yellow lines) and both of these interfaces are in the same Port Group. This means we shared data between the two VMs using only a single port.
+\\
 \\
 {{ :shared_interface.jpg?450 |}}
@@ Line 42: / Line 46: @@
 \\
+----
+==== Three Server Example ====
-\\
-\\
-\\
-\\
-\\
-\\
 Consider my example below, I three servers, all connected to a switch, and I am passing multicast traffice between them, that is being processed in a particular way at each stage. Basically I want an input, two processing stages, a storage device and an output.
 \\
@@ Line 75: / Line 70: @@
 \\
 \\
-{{ :esxi_virtual_switch_and_port_groups_port_group_members_and_adapters.jpg?500 |}}
+{{ :esxi_virtual_switch_and_port_groups_port_group_members_and_adapters.jpg?450 |}}
 \\
 Above we can see the following:
@@ Line 110: / Line 105: @@
 \\
 \\
-{{ ::vm_interfaces_01.jpg?700 |}}
+{{ ::vm_interfaces_01.jpg?600 |}}
 \\
 There are three Network Adapters that have been added to each VM (this is for the MFEL VM). Each network has then been assigned to a Port Group (so you need to create your Port Groups and Switches before your VMs).
@@ Line 121: / Line 116: @@
 \\
 \\
-{{ :vswitch_diagram.png?600 |}}
+{{ :vswitch_diagram.png?450 |}}