dual_output_el_switch_on_loss_of_all_output_interfaces
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
dual_output_el_switch_on_loss_of_all_output_interfaces [2024/05/23 17:15] – [nCompass Changes] walkeradmin | dual_output_el_switch_on_loss_of_all_output_interfaces [2024/05/23 17:19] – [nCompass Changes] walkeradmin | ||
---|---|---|---|
Line 75: | Line 75: | ||
\\ | \\ | ||
<add key=" | <add key=" | ||
- | \\ | ||
\\ | \\ | ||
It is line 165 in this example, this line does change over time as things are added to the nCompass Configuration. | It is line 165 in this example, this line does change over time as things are added to the nCompass Configuration. | ||
+ | \\ | ||
\\ | \\ | ||
{{ : | {{ : | ||
\\ | \\ | ||
+ | Add your EL output interfaces to this line - <add key=" | ||
+ | \\ | ||
+ | \\ | ||
+ | What this means is that only when (in this example) eno3 and eno4 are failed, will the Encoder switch. | ||
+ | \\ | ||
+ | \\ | ||
+ | You can use this command to test the state of the encoder | ||
+ | \\ | ||
+ | \\ | ||
+ | http://< | ||
+ | \\ | ||
+ | < | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | }, | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | " | ||
+ | }, | ||
+ | </ | ||
+ | === === | ||
dual_output_el_switch_on_loss_of_all_output_interfaces.txt · Last modified: 2024/05/24 10:13 by walkeradmin