dual_output_el_switch_on_loss_of_all_output_interfaces
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
dual_output_el_switch_on_loss_of_all_output_interfaces [2024/05/23 16:56] – [Remove Dual Output Prevention from EL] walkeradmin | dual_output_el_switch_on_loss_of_all_output_interfaces [2024/05/23 17:16] – [nCompass Changes] walkeradmin | ||
---|---|---|---|
Line 41: | Line 41: | ||
\\ | \\ | ||
=== Alarm Criticality === | === Alarm Criticality === | ||
+ | \\ | ||
+ | By default, an interface down on an Encoder will result in a <color # | ||
+ | \\ | ||
+ | \\ | ||
+ | Unplug the first output data interface on the first EL, this will cause an Alarm in nCompass ESM. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | Because this system is encoding four services, I get an alarm for each service: | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | Right click on one of the alarms and select ' | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | Now select the ' | ||
+ | \\ | ||
+ | \\ | ||
+ | This fixes the issue where an encoder will switch on a single interface alarm, however at this time the encoder will never switch due to interface alarms, we need to make some more changes. | ||
+ | \\ | ||
+ | \\ | ||
+ | === nCompass AlarmHandlerService.exe.config === | ||
+ | \\ | ||
+ | The nCompass AlarmHandlerService.exe.config file is found in the following location: | ||
+ | \\ | ||
+ | C:\Program Files (x86)\MediaKind\nCompass Control\Bin | ||
+ | \\ | ||
+ | Open this file in notepad++ (or your favorite editor, just not notepad) and scroll down until you see the line: | ||
+ | \\ | ||
+ | <add key=" | ||
+ | \\ | ||
+ | It is line 165 in this example, this line does change over time as things are added to the nCompass Configuration. | ||
+ | \\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | Add your EL output interfaces to this line - <add key=" | ||
+ | \\ | ||
+ | \\ | ||
+ | What this means is that only when (in this example) eno3 and eno4 are failed, will the Encoder switch. | ||
+ | \\ | ||
+ | \\ | ||
+ | |||
+ | |||
+ |
dual_output_el_switch_on_loss_of_all_output_interfaces.txt · Last modified: 2024/05/24 10:13 by walkeradmin