dual_output_el_switch_on_loss_of_all_output_interfaces
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| dual_output_el_switch_on_loss_of_all_output_interfaces [2024/05/23 16:50] – [Remove Dual Output Prevention from EL] walkeradmin | dual_output_el_switch_on_loss_of_all_output_interfaces [2024/05/23 16:56] – [Remove Dual Output Prevention from EL] walkeradmin | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Dual Output EL Switch on loss of all output interfaces ====== | ====== Dual Output EL Switch on loss of all output interfaces ====== | ||
| - | <color # | + | <color # |
| \\ | \\ | ||
| \\ | \\ | ||
| Line 32: | Line 32: | ||
| \\ | \\ | ||
| ---- | ---- | ||
| - | ==== ==== | + | ==== nCompass Changes |
| + | \\ | ||
| + | There are a couple of things we need to change in nCompass. One is the criticality of an alarm and the other is a config file. | ||
| + | \\ | ||
| + | \\ | ||
| + | We know that if one of our output interfaces goes down, the ELs will switch, for this reason we need to change the criticality of an interface down alarm. If we do this and nothing else, if both interfaces go down, then we will NOT get an encoder switch, so we need to change an nCompass file. | ||
| + | \\ | ||
| + | \\ | ||
| + | === Alarm Criticality | ||
dual_output_el_switch_on_loss_of_all_output_interfaces.txt · Last modified: 2024/05/24 10:13 by walkeradmin